Toro 46452, Руководство оператора

Страница: 16 / 36

g348674
Figure 21
1. Scarifying slot
3. Jam nut
2. Frasing slot 4. Rear link
4. Using the adjustment handles, adjust the
front links to your desired depth by using the
indicators on both sides.
5. Check the working depth by running the machine
a few meters (yards). Refer to
Operating the
Attachment (page 18) .
6. If needed, adjust the front links until you reach
your desired depth.
Note:
When the lift conveyor is folded out, the
machine weight shifts to this side. Due to the
extra weight, you can remove more material on
this side. To compensate for this extra weight,
adjust the front and back links on the right side
(lift conveyor side).
g348709
Figure 22
1. Adjustment handle
Adjusting the Scarifying Depth
The working depth is set by adjusting the front roller.
Ensure the rear roller is set to the scarifying slot
shown in
Figure 21 .
Important:
Adjust the working depth only when
the traction unit is parked, the parking brake is
engaged, the PTO is disengaged, and the engine
is shut off.
1. Loosen the jam nut on the top of each rear link.
2. Adjust the rear links until they align with the
scarifying slot in the gauge (
Figure 21 ).
3. Tighten the jam nut for each rear link ( Figure 21 ).
4. Using the adjustment handles, adjust the
front links to your desired depth by using the
indicators on both sides (
Figure 22 ).
5. Check the working depth by running the machine
a few meters (yards). Refer to
Operating the
Attachment (page 18) .
6. If needed, adjust the front links until you reach
your desired depth.
16