G021675
1
Figure 6
1.
Lift loop
7.
Carefully remove the screws holding the blower to the
wood pallet. After the screws are removed, slide the
crate away from the blower and lower the blower until
the castor wheels touch the floor but the strap is still
tight (Figure 7).
G021676
1
Figure 7
1.
Screws
8.
Insert the jack stand tube into the frame tube, align
the holes and secure it into position with the snapper
pin (Figure 8).
G021637
1
2
3
Figure 8
1.
Frame tube
3.
Jack stand
2.
Snapper pin
9.
Remove the cable tie securing the crank handle to the
jack crank.
10.
Crank the jack stand down until the jack pad is level
with the castor wheel tires.
11.
Remove the strap from the blower lift loop.
2
Installing the Drive Shaft to the
Blower Gear Box Shaft
Parts needed for this procedure:
1
Drive shaft assembly
1
Roll pin
2
Bolt, 5/16 x 1-3/4 inch
2
Lock nut, 5/16 inch
Procedure
1.
Remove the cable tie securing the drive shaft to the
shipping crate.
2.
Slide the drive shaft onto the gear box shaft. Align the
mounting holes in the gear box shaft with the holes in
the drive shaft and slide them together.
8
