Toro 44536, Руководство оператора

Страница: 6 / 16

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
No parts required
–
Install the caster wheels.
2
No parts required
–
Connect the lower link arms.
3
No parts required
–
Connect the upper link.
4
No parts required
–
Adjust the PTO shaft length.
5
No parts required
–
Connect the PTO shaft.
6
No parts required
–
Adjust the sway links.
7
No parts required
–
Adjust the 3-point-lift stop.
8
No parts required
–
Remove the blower from the tractor.
9
No parts required
–
Grease the blower.
Media and Additional Parts
Description Qty. Use
Operator's Manual 1 Review the manual before operating the machine.
Parts Catalog 1 Use the parts catalog to reference product part numbers.
CE Decal 105-0698 1 Apply over decal 105-0707 for CE compliance.
Note:
Determine the left and right sides of the machine
from the normal operating position.
1
Installing the Caster Wheels
No Parts Required
Procedure
Install a caster wheel assembly between each caster fork with
4 washers, an axle, and 2 cotter pins (
Figure 2 ).
Figure 2
1. Wheel assembly 3. Axle
2. Caster fork
6