Toro 44225, Руководство оператора

Страница: 23 / 32

g011413
Figure 28
1. Hopper seal 2. Gate edge
Important:
The fasteners on the covers of this
machine are designed to remain on the cover
after removal. Loosen all of the fasteners on
each cover a few turns so that the cover is loose
but still attached, then go back and loosen them
until the cover comes free. This will prevent you
from accidentally stripping the bolts free of the
retainers.
1. Remove the chain cover assembly and spacer
(
Figure 29 ).
g011409
Figure 29
1. Chain cover 2. Spacer (under cover)
2. Remove the master link from the chain and
remove the chain from the small sprocket
(
Figure 30 ).
g011414
Figure 30
1. Drive chain 3. Motor
2. Master link
Note:
You may have to loosen the motor
mounting bolts to disassemble the chain link.
3. Loosen the jam nuts and the nuts on the tension
rod to release the spring tension (
Figure 31 ).
g011415
Figure 31
1. Tension nuts 2. Nuts
4. Remove 2 cap screws, washers, and nuts on
each side of the machine, securing the hopper
to the slider bed (
Figure 32 ).
g011416
Figure 32
1. Hopper mounting cap screws (right side shown)
23