4. Install a barbed fitting into the end of the longer
supply hose section and secure it with a hose clamp
next to the fitting body.
Important:
Apply liquid soap to the barbed
fitting to lubricate it. You must install the
hose all the way onto the barb. Do not use
petroleum-based lubricants such as grease or
oil because they can damage the hose and
contaminate the system.
5. Attach the fitting on the end of the longer supply
hose section to the tee.
6. Attach the fitting on the end of the shorter supply
hose section to the boom valve assembly.
7. Attach the flowmeter bracket to the rear of the boom
valve mounting bracket using 2 flange head screws
(1/4 in.) and flange nuts.
8. Assemble the gaskets and barbed fittings on the
hoses to the flowmeter using 2 worm screw clamps
Figure 4).
Important:
Note the direction of the flow on
the side of the flowmeter and ensure that the
flowmeter is installed properly (Figure 4).
9. Secure the flowmeter to the hoses with 2-inch worm
screw clamps.
10. Secure the supply hoses to the flowmeter mounting
bracket with 2 hose clamps (Figure 4).
11. Install a barbed fitting into the end of the shorter
supply hose section and secure it with a hose clamp
next to the fitting body.
12. Connect the plug from the flowmeter to its mate
plug in the wiring harness.
Closing the Boom Valves
This system is designed to work with a diaphragm pump
and must operate with the boom bypass valves closed.
Important:
Before operating the spray system with
the console computer, close all bypasses on your
boom valves by turning in the red adjustment knob
at the bottom of the boom valves clockwise as far
as possible.
Installing the ProControl
For Model Year 2010 and
Newer only.
Installing the Console Computer
1. Locate and remove the knockout plug in the
dashboard. Install the large grommet into the
opening in the dash (Figure 6).
G013319
1
2
3
4
5
6
7
8
9
10
Figure 6
1.
Pivot bracket (2010 and
newer only)
6.
Mounting hole in
dashboard, existing
2.
Hand knob
7.
Large grommet
3.
Console computer
8.
Lock nut (5/16 inch)
4.
Carriage bolt (5/16 x 3/4
inch)
9.
Knocked out hole in dash
5.
Lock nut (5/16 inch)
10.
Mounting bracket
2. Locate the mounting bracket with the curved slot in
loose parts. Install the bracket to the dashboard and
secure it with two carriage bolts (5/16 x 3/4 inch)
and two lock nuts (5/16 inch) as shown in Figure 6.
3. Locate the round, multi-pin console computer
connectors on the main harness secured to the right
frame member under the dashboard.
4. Cut the plastic tie that secures the console computer
wiring to the frame under the dashboard. Remove
the 2 protective caps from the cable ends.
5. Route the console computer cables from under the
dashboard through the hole with the large grommet.
6
