Toro 38701, Руководство оператора

Страница: 16 / 36

•
19° to the left
•
Straight ahead
•
19° to the right
5. Once the broom is positioned, release the
broom angle lever.
Important:
Ensure that the broom locks into
place at one of the 3 positions.
6. Release the left wheel-clutch lever.
Using the Alternate Caster
Location
When working in snow, move the casters from the
front of the broom arm to the back the broom hood
(
Figure 21 ).
g326877
Figure 21
1. Broom hood 4. Broom arm
2. Carriage bolt 5. Washer
3. Caster bracket 6. Locknut
1. Support the broom.
2. Remove the 2 locknuts, 2 washers, and 2
carriage bolts (
Figure 21 ) that secure the caster
bracket to the broom arm.
3. At the back of the broom hood, align the holes in
the caster bracket with the holes on the inboard
side of the broom arm (
Figure 21 ).
4. Secure the caster bracket to the broom arm with
the 2 locknuts, 2 washers, and 2 carriage bolts
(
Figure 21 ).
Clearing a Clogged Broom
WARNING
The rotating broom could cause serious
injury.
Shut off the engine and allow all rotating parts
to stop before cleaning the broom.
•
If the broom becomes clogged, stay in the
operating position and release the traction-drive
lever. While engaging the broom, push down on
the handles to raise the front of the machine a
few centimeters (inches) off the pavement. Then
lift the handles quickly to bump the front of the
machine on the pavement. Repeat if necessary.
•
If you cannot unclog the broom by bumping the
front of the machine, do the following:
– Park the machine on level ground. shut off the
engine, wait for all moving parts to stop, and
disconnect the spark-plug wire.
– Sharp objects can become entangled in
bristles. Use gloves and caution when
removing foreign objects from the broom; do
not use your hands.
After Operation
After Operation Safety
General Safety
•
Never store the machine with fuel in the fuel
tank inside a building where ignition sources are
present, such as hot water heaters, space heaters,
or clothes dryers. Allow the engine to cool before
storing the machine in any enclosure.
•
When storing the machine for more than 30
days, refer to the Storage section for important
information.
•
When operating in snowy conditions, run the
machine for a few minutes after removing snow to
prevent freeze-up of the broom and housing.
•
When cleaning, repairing, or inspecting the
machine, ensure that the rotary broom and all
moving parts have stopped. Disconnect the
spark-plug wire and keep it away from the plug to
prevent accidental starting.
•
Disengage the power to the rotary broom when
transporting or storing the machine.
16