Toro 38535, Руководство оператора

Страница: 9 / 24

9
1
2
4
3
m5573
Figure 6
1. Knob (2)
2. Curved washer (2)
3. Upper handle
4. Handle lock (2)
4. Insert the loose end of the control cable into the bottom
hole in the control bar. Refer to Fig. 7 (Models 38535
and 38536) or Fig. 8 (Models 38537 and 38538).
1
3
2
5
4
m5533
Models 38535
and 38536
Figure 7
1. Top hole
2. Bottom hole
3. Control bar
4. Spring cover
5. Control cable
m-5519
4
3
2
1
Models 38537
and 38538
Figure 8
1. Cable
2. Control bar
3. Top hole
4. Bottom hole
5. Fully insert the handle locks (Fig. 6).
Important Ensure that the control cable is not pinched
by the upper handle or the handle lock.
6. Tighten the knobs until they are snug.
7. Adjust the control cable. Refer to Adjusting the Control
Cable on page 16.
Installing the Discharge Chute
Models 38535 and 38536
1. Place the discharge chute over the chute ring, and align
the hole in the back of the discharge chute with the
center hole in the chute ring (Fig. 9).
1
2
3
m5520
Figure 9
1. Chute ring
2. Discharge chute
3. Chute handle
2. Insert a screw through the center hole of the chute ring
from the inside and through the hole in the discharge
chute (Fig. 9).
3. Insert the chute handle over the discharge chute, and
fully insert the screw through the center hole in the
chute handle (Fig. 9).
4. Install a washer and a locknut on the screw, and tighten
the locknut until it is finger tight.
5. Align the remaining holes of the chute handle, the
discharge chute, and the chute ring, and insert the 2
remaining screws through the holes from the inside of
the chute ring.
6. Install the washers and the locknuts on the screws, and
tighten the locknuts until they are finger tight.
7. Tighten all locknuts securely.