Toro 38472, Руководство оператора

Страница: 4 / 24

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
Oval-head bolts 2
Curved washers 2
1
Handle knobs 2
Install the handle.
2
No parts required
–
Install the recoil starter handle.
Discharge chute 1
Screws 2
Washers 2
Locknuts 2
3
Knob 1
Install the discharge chute.
4
Bottle of engine oil 1 Fill the engine with oil.
5
No parts required
–
Adjust the control cable.
1
Installing the Handle
Parts needed for this procedure:
2 Oval-head bolts
2
Curved washers
2 Handle knobs
Procedure
1. Position the ends of the upper handle on the inside of
the lower handle and align the holes.
2. Insert the oval-head bolts into the aligned holes, with
the bolt heads on the outside of the handle (
Figure 3 ).
Figure 3
1. Oval-head bolt (2) 2. Curved washers and
handle knobs
3. Install the curved washers and the handle knobs on the
oval-head bolts on the inside of the handle (
Figure 3 )
and tighten the knobs securely .
Important:
Ensure that the cable is routed to the
outside of the handle.
4