Toro 38451, Руководство оператора, Страница: 9 / 20

Figure 14
1. Choke lever
Figure 15
1. Symbols on the choke lever indicating to move the choke
lever to the right to activate the choke.
3. Firmly push in the primer 3 times with your thumb,
holding the primer in a for a second before releasing
it each time (Figure 16).
Figure 16
Note:
Remove your glove when you push in the
primer so that air cannot escape from the primer
hole.
Important:
Do not use the primer or the choke
if the engine has been running and is hot.
Excessive priming may flood the engine and
prevent it from starting.
4. Connect an extension cord to a power source and
the machine, and push the electric-start button
(model 38452 only) (Figure 17), or pull the recoil
start handle (Figure 18).
Figure 17
Note:
Use only a UL-listed, 16-gauge extension
cord recommended for outdoor use that is not
longer than 50 feet (15 m).
WARNING
The electrical cord can become damaged,
causing a shock or fire.
Thoroughly inspect the electrical cord before
plugging it into a power source. If the
cord is damaged, do not use it to start the
machine. Replace or repair the damaged cord
immediately. Contact an Authorized Service
Dealer for assistance.
Figure 18
Important:
Run the electric starter no more
than 10 times at intervals of 5 seconds on, then
5 seconds off. Running the electric starter
extensively can overheat and damage it. If the
engine does not start after this series of attempts,
wait at least 40 minutes to allow the starter to
cool before attempting to start it again. If the
engine does not start after the second series of
attempts, take the machine to an Authorized
Service Dealer for service (model 38452 only).
9