
5
Converting from
Snowthrowing to Sweeping
Important
: Disconnect the power from the Power
Shovel Plus before performing this procedure.
1.
Remove the
bolt on the side of
the housing.
m-7386
2.
Remove the
snowthrower rotor
from the housing.
m–7397
3.
Install the
broom in the
housing.
m-7388
4.
Secure the
broom with the bolt
that you previously
removed.
m-7389
5.
Tighten the
bolt on the side of
the housing.
m-7386
6.
Install the
deflector.
m–7694
Note:
The
deflector snaps
into place.
m–7693
7.
Loosen the
lower knob on the
shaft.
8.
Rotate the
handle grip to the
opposite side of
the shaft.
9.
Tighten the
knob.
m-7385
10.
Ensure that the
Power Shovel Plus
is in the broom
mode as shown.
m–7692
Note:
You may need to adjust the length of the shaft
to comfortably operate in broom mode. Refer to
Adjusting the Power Shovel Plus Height on page 3.