Toro 34215, Руководство оператора

Страница: 45 / 80

Cleaning the Strainer
Service Interval: After each use
Important:
If you used wettable-powder
chemicals, clean the strainer after each time that
you rinse the sprayer tank.
1. Empty the sprayer tank; refer to Emptying the
Sprayer Tank (page 39) .
2. Rotate the handle of the pump-shutoff valve 90°
counterclockwise to the
CLOSE
position ( Figure
51 ).
g249175
Figure 51
1. Strainer 2. Pump-shutoff valve
3. Align a drain pan under the strainer ( Figure 51 ).
4. Rotate the strainer bowl counterclockwise and
remove the bowl and screen from the body of
the strainer (
Figure 52 ).
Note:
Remove the strainer bowl by hand.
Note:
Replace the gasket or screen or both if
these parts are worn or damaged
g027402
Figure 52
1. Strainer body 3. Screen
2. Gasket 4. Strainer bowl
5. Allow any residual chemical solution to drain
from the strainer body.
Note:
Dispose of the waste solution according
to local codes and the chemical manufacturer's
instructions.
6. Use a soft-bristle brush and clean water to clean
the screen and bowl
7. Install the screen into the strainer body (. Figure
52 ).
8. Install the gasket and strainer bowl onto the
strainer body, and hand tighten the bowl (
Figure
52 ).
9. Rotate the handle of the pump-shutoff valve 90°
clockwise to the
OPEN
position ( Figure 51 ).
Cleaning the Sprayer Nozzle
Service Interval: After each use
1. Rotate the nozzle cap 90° counterclockwise and
remove the cap from the nozzle body (
Figure
53 ).
45