Toro 34215, Руководство оператора

Страница: 15 / 80

Note:
Do not use agitation while spraying. Shut
off the tank agitation to ensure proper spray
distribution.
Note:
Run the engine speed above idle and run the
sprayer pump for the tank agitation to work effectively.
Narrow-Spray Pattern Lever
The narrow-spray pattern lever is located on the
control console (
Figure 12 ).
•
To turn
ON
the sprayer in a narrow-spray pattern
(the center nozzle only), pull the narrow-spray
pattern lever toward you.
•
To turn
OFF
the sprayer, push the narrow-spray
pattern lever away from you.
Wide-Spray Pattern Lever
The wide-spray pattern lever is located on the control
console (
Figure 12 ).
•
To turn O
N
the sprayer in a wide-spray pattern (the
right and left nozzles), pull the wide-spray pattern
lever toward you.
•
To turn O
FF
the sprayer, push the wide-spray
pattern lever away from you.
Sprayer-Pressure Gauge
The sprayer-pressure gauge is located on the control
console (
Figure 12 ).
Use the pressure gauge to see the fluid pressure in
the sprayer system.
Sprayer-Pump Switch
The sprayer-pump switch is located on the control
console (
Figure 12 ).
Use the sprayer-pump switch to start and stop the
pump when spraying or circulating the fluid in the
sprayer tank (tank-agitation).
•
To start the pump, push down on the top of the
sprayer-pump switch.
•
To stop the pump, push down on the bottom of
the switch.
Spray-Wand Trigger and Trigger Lock
The spray-wand trigger and trigger lock are located
on the bottom of the spray-wand handle (
Figure 12
and Figure 13 ).
•
To use the spray wand, hold the handle of the
wand squeeze the trigger.
•
To lock the trigger to the O
N
position, fully squeeze
the trigger against the handle and then latch the
trigger lock over the trigger; to unlock the trigger,
unlatch the trigger lock from the trigger.
•
Release the trigger to stop the spray.
g033343
Figure 13
1. Trigger lock 3. Trigger
2. Spray-wand handle
Tank Drain Valve
The tank drain valve is located at the left side and
under the sprayer tank (
Figure 15 ).
Use the tank drain valve to empty the sprayer tank
of liquid chemicals.
g027226
Figure 14
1. Handle (open position) 3. Sprayer tank
2. Tank drain valve
•
To open the valve, rotate the handle of the tank
drain valve 90° clockwise (lever in-line with valve).
•
To close the valve, rotate the handle 90°
counterclockwise.
Sprayer-Pump-Supply Valve
The sprayer-pump-supply valve is located at the
right side of the machine and under the sprayer tank
(
Figure 15 ).
Use the sprayer-pump-supply valve to shut off the
flow of liquid chemicals to the pump.
15