Toro 31970, Руководство оператора, Страница: 18 / 28

CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours Lubricate the
grease fittings immediately after
every washing.
The machine has grease fittings that you must
lubricate regularly with No. 2 lithium grease.
1. Park the machine on a level surface, lower the
cutting unit, engage the parking brake, shut off
the engine, and remove the key.
2. Lubricate the following areas:
•
Castor fork shaft bushings (4) ( Figure 15 ).
g011557
Figure 15
•
Spindle shaft bearings (3—located under the
pulley) (
Figure 16 )
g297468
Figure 16
•
Idler arm shaft bearings ( Figure 16 )
18