Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Prepare the machine.
2
No parts required
–
Install the CE kit (if required).
Hex-head bolt
2
Washer
2
3
Height-of-cut pin
2
Install the cutting unit to the traction unit.
Shoulder bolt
2
4
Spacer
2
Install the PTO cover.
5
No parts required
–
Level the cutting unit.
6
No parts required
–
Grease the machine.
WARNING
If you leave the key in the switch, someone could accidentally start the engine and seriously
injure you or other bystanders.
Remove the key from the switch before you install the cutting unit
DANGER
If the engine is started and the PTO shaft is allowed to rotate, serious injury could result.
Do not start the engine and engage the PTO switch when the PTO shaft is not connected
to the gearbox on the cutting unit.
Note:
Determine the left and right sides of the machine from the normal operating position.
8
