Toro 319000001, Руководство оператора

Страница: 8 / 20

2
Unfolding the Handle
No Parts Required
Procedure
1. Remove the machine from the box.
2. Unfold the upper handle and allow the upper
handle knobs to snap into place (A of
Figure 3 ).
3. Tighten the handle knobs (B of Figure 3 ).
g282574
Figure 3
4. Remove the lower handle knobs from both sides
of the machine (
Figure 4 ).
Note:
The lower knobs are installed to a weld
nut in the side of the machine.
g303594
Figure 4
Right side shown
1. Lower handle knob
5. Move the lower handle into place and install the
lower handle knobs as shown in
Figure 5 .
Note:
You may use a wrench on the hex on the
outside of the knob to tighten the knob.
Important:
Tighten the knobs until the
handlebar touches the side plate with no gap.
g303595
Figure 5
1. Align the lower handle with
the weld nuts. 2. Install the lower handle
knobs.
8