Toro 31698, Руководство оператора, Страница: 77 / 100

1. Park the machine on a level surface, engage the
parking brake, lower the cutting deck, and shut
off the engine.
2. Sit in the operator seat and have the other
person make the connections.
Note:
Ensure that the jumper battery is a 12V
battery.
Important:
If you are using another machine
for power, ensure that the 2 machines are
not touching each other.
3. Remove the covers from the jump posts ( Figure
107 ).
4. Connect the positive (+) jumper cable to the
positive jump post (
Figure 109 ).
g033269
Figure 109
1. Positive (+) jump post 3. Negative (-) jumper-cable
clamp
2. Negative (-) jump post 4. Positive (+) jumper-cable
clamp
5. Connect the negative (-) jumper cable to the
negative jump post (
Figure 109 ).
6. Start the engine.
Important:
If the engine starts and then
stops, do not operate the starter motor until
the starter motor stops turning. Do not
operate the starter motor for more than 30
seconds at one time. Wait 30 seconds before
operating the starter motor to cool the motor.
7. When the engine starts, have the other person
disconnect the negative (-) jumper cable from
the negative jump post and then disconnect the
positive (+) jumper cable (
Figure 109 ).
Removing the Batteries
1. Open the hood and turn the battery-disconnect
switch to the O
FF
position.
2. Remove the three 3 flange screws from each
side of the rear bumper as shown in
Figure 110 .
3. Loosen the remaining flange screws securing
the rear bumper to the frame and pivot the
bumper downward.
g199824
Figure 110
1. Rear bumper 3. Remove these 3 flange
screws on both sides.
2. Loosen this flange screw
on both sides.
4. Loosen the knobs and remove both side shrouds
(
Figure 111 ).
g199825
Figure 111
1. Knobs 2. Remove the side shrouds
on both sides
5. Remove the 6 flange screws securing rear
shroud to the frame and remove the rear shroud
(
Figure 112 ).
77