Toro 31698, Руководство оператора, Страница: 19 / 100

g008868
Figure 7
1. Winglet 4. Eccentric
2. Hinge pin 5. Upper hole
3. Stop bolt
3. Rotate the forward eccentric until it reaches
maximum clearance with the inner-slot surface
of the winglet-pivot bracket.
4. Rotate the rear (closest to the traction unit)
eccentric until the outside blade tip is about 3
mm (1/8 inch) higher than the desired height of
cut (
Figure 7 ).
Note:
There is a notch on the eccentric hex,
which is 180° from the lobe on the eccentric
cam (
Figure 8 ). Use the notches to reference
the location of the lobes when adjusting the
eccentrics.
g009153
Figure 8
1. Eccentric notch
5. Tighten the bolt and nut for this eccentric to 149
N·m (110 ft-lb).
6. Adjust the forward eccentric until it just makes
contact with the inner slot surface of the
winglet-pivot brackets.
7. Tighten the bolt and nut for this eccentric to 149
N·m (110 ft-lb).
8. Repeat the procedure on the opposite winglet.
6
Checking the Fluid Levels
No Parts Required
Procedure
1. Check the engine-oil level before starting the
engine; refer to
Checking the Engine-Oil Level
(page 69) .
2. Check the hydraulic-fluid level before starting
the engine; refer to
Checking the Hydraulic Fluid
(page 86) .
3. Check the cooling system before starting the
engine; refer to
Checking the Engine-Cooling
System (page 80) .
7
Greasing the Machine
No Parts Required
Procedure
Grease the machine before use; refer to Lubrication
(page 65) .
Important:
Failure to properly grease the
machine will result in premature failure of critical
parts.
19