Toro 31598N, Руководство оператора

Страница: 47 / 68

6. Operate the water separator priming pump until a solid
stream of fuel is detected at the banjo fitting (
Figure
66 ).
7. Tighten the fuel filter banjo fitting.
8. Push down the priming pump and turn it clockwise
to secure.
9. Start the engine and check for fuel leaks around the
filter head.
Electrical System
Maintenance
WARNING
If installing an auxiliary accessory to the machine,
the only approved locations to source power are
the traction unit fuse block (
Figure 69 ) or the cab
fuse block ( Figure 71 ). A maximum of 10 amps is
available from either location. Contact your local
Toro distributor for assistance.
Note:
Make sure the key is off and removed from the switch
before removing fuses.
Fuses
The traction unit fuses ( Figure 69 ) are located in the power
center console ( Figure 68 ).
g021 155
Figure 67
Figure 68
1. Power center console 2. Knob
47