Form No. 3435-312 Rev A
Backup Alarm Kit
Model No. 31512
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Prepare the machine.
Backup alarm
1
Hex-head screw (1/4 x 3/4 inch)
2
Flange nut (1/4 inch)
2
Wire harness
1
Tie clip
2
Clamp
1
2
Cable tie
2
Install the backup alarm.
3
No parts required
–
Enable the alarm in the InfoCenter.
4
No parts required
–
Check the backup alarm.
The Backup Alarm Kit can be installed on the following
machines:
•
Groundsmaster 4000 Series
•
Groundsmaster 4100 Series
•
Groundsmaster 5900 Series
Note:
This kit is not for use on the Outcross 9060.
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Lower the cutting units.
3.
Engage the parking brake.
4.
Shut off the engine and remove the key.
5.
Disconnect the negative battery cable from the
battery.
6.
Disconnect the positive battery cable from the
battery.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3435-312* A
