Toro 315000001, Руководство оператора

Страница: 14 / 32

5
Assembling and Mounting the
4-Way Valve
Parts needed for this procedure:
1 4-way valve
1 Straight-barbed fitting(1 inch NPT x 3/4 inch)
2 90-degree barbed fitting (1 inch NPT x 3/4 inch)
1 Straight-barbed fitting (3/4 inch NPT x 1/2 inch)
1 Reducer fitting (1 inch NPT x 3/4 inch NPT)
1 Faceplate bracket
1 Valve-mount assembly
4 Bolt (6 mm)
4 Flat washer (6 mm)
4 Locknut (6 mm)
2 Nut (3/8 inch)
2 Bolt (3/8 inch)
Procedure
Note:
Apply PTFE tape to the threads of the taper-threaded
fittings used in the sprayer and rinse systems.
1. Assemble the 90°-barbed fittings, straight-barbed
fitting (1 inch NPT x 3/4 inch), reducer fitting, and
straight-barbed fitting (3/4 inch NPT x 1/2 inch) into
the 4-way valve as shown in
Figure 24 .
Important:
Align the 90° barbed fittings as shown
in Figure 24 .
1
2
4
3
5
g024698
Figure 24
1. 90° barbed fitting (1 inch
NPT x 3/4 inch) 4. 4-way valve
2. Straight-barbed fitting (1
inch NPT x 3/4 inch) 5. Straight-barbed fitting (3/4
inch NPT x 1/2 inch)
3. Reducer fitting (1 inch
NPT x 3/4 inch NPT)
2. Insert 4 bolts (6 x 16 mm) and 4 washers (6 mm) into
the slots of the 4-way valve (
Figure 25 ).
Figure 25
1. 4-way valve 3. Washer (6 mm)
2. Bolt (6 x 16 mm)
3. Assemble the 4-way valve onto the valve mount ( Figure
26 ) with 4 locknuts (6 mm).
1
2
3 4
g024703
Figure 26
1. Locknut (6 mm) 3. Washer
2. 4-way valve 4. Bolt
4. Install the faceplate bracket onto the valve-mount
assembly (
Figure 27 ) with 2 flange bolts (5/16 x 1 inch)
and 2 flange locknuts (5/16 inch).
14