Toro 31351, Руководство по установке

Страница: 2 / 12

Installation
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Lower the cutting units.
3. Engage the parking brake.
4. Shut off the engine and remove the key.
5. If there are lights on the roll bar, remove the
lights and the mounting hardware from the roll
bar.
Retain the lights and the mounting hardware.
6. Remove the locking pins from both sides of the
roll bar (
Figure 1 ).
g204506
Figure 1
1. Roll bar 2. Locking pin
7. Remove the bolts from both sides of the foot
frame (
Figure 2 ) as shown in Figure 3 and
Figure 4 .
g204217
Figure 2
Foot frame
g204504
Figure 3
Left side shown
1. Bolt 2. Drill hole—3/8 inch
g204505
Figure 4
Right side shown
1. Bolt 2. Drill hole—3/8 inch
8. Use a drill (3/8 inch) to increase the diameter of
the 2 holes on both sides of the foot frame as
shown in
Figure 3 and Figure 4 .
2