Toro 31102, Руководство по установке

Страница: 11 / 16

Connecting the Long Hose
(2WD Models Only)
This procedure does not apply to 4WD models.
1. Install the end of the long hydraulic hose to the inboard
port of the right wing cylinder and tighten the fitting.
2. Route the hose from the right wing cylinder along the
mid-length hose, under the hydraulic tank bracket,
above the lift shaft, and below the floorboard support
to the capped fitting on the hydraulic hard line (
Figure
17 and Figure 18 ).
g027153
Figure 17
1. Capped fitting
g027154
Figure 18
Some parts not shown
1. Floorboard support 3. Right wing cylinder hose
2. Lift shaft 4. Hydraulic line fitting
3. Remove and discard the cap from the fitting ( Figure
17 ).
4. Connect the right wing cylinder hose to the fitting on
the hydraulic line (
Figure 18 ) and tighten the fitting.
Note:
Make sure that the hose is not twisted and will
not contact any hot, sharp, or moving parts.
11