Toro 30818, Руководство по установке

Страница: 5 / 16

5. Move the carrier frame up to the roll bar bracket and
secure it using a tabbed pin through the rear hole in
the bracket (
Figure 4 ).
Note:
Place the tab over the end of the pivot bolt.
6. Secure the pivot bolt and tabbed pin using the nut you
removed previously (
Figure 4 ).
7. Remove the pin from the other side of the roll bar and
repeat this procedure to secure the other side of the
carrier frame to the machine.
Figure 6 illustrates the correctly installed carrier frame.
g029470
Figure 6
Installing the
High-Lift-Collection Kit
Installing the High-Lift-Collection
Assembly
1. Secure and lift the high-lift-collection assembly using
a hoist. Ensure that the straps you use to hoist it only
contact the steel frame under the hopper.
Important:
Do not lift the grass collector by the
plastic hopper or you will damage it.
2. Slowly lower the high-lift-collection assembly onto the
frame and slide it forward until the cooler assembly on
the front of the hopper is about 2.5 cm (1 inch) from
the plate on the carrier frame (
Figure 7 ).
Figure 7
1. Opening in the
carrier-frame plate 3. Bolt (4 required)
2. Cooler 4. Shipping brackets (2),
remove and discard
3. Remove the fasteners securing the shipping brackets to
the top of the cooler and discard them (
Figure 7 ).
4. Slide the high-lift-collection assembly forward so that
the tabs on the front of the cooler are flush with the
plate on the carrier frame (
Figure 7 ) and the tabs in the
steel frame of the high-lift-collection assembly sit inside
the holes on the carrier frame as shown in
Figure 8 .
g029471
Figure 8
5