Toro 30818, Руководство по установке

Страница: 11 / 16

Troubleshooting
Problem Possible Cause Corrective Action
The suction port is blocked. 1. The machine is being driven too fast
for the given conditions.
1. Operate the machine at a slower pace.
The suction hose or pressure channel is
clogged. 1. Grass or debris has accumulated in
the hose.
1. Clean out the hose.
1. The exhaust grill or filter is dirty. 1. Clean the exhaust grill and filter.
2. The engine speed of the machine is
too low.
2. Operate the machine at a higher
engine speed.
The suction capacity is poor.
3. One or more belts are loose. 3. Check the tension of the belt and
tighten it if necessary. (Note: There is
a double belt on the hopper driving the
fan and a single belt under the hood of
the machine driving the pump.)
There is a strong vibration when the
blower is running. 1. The fan blades are out of balance. 1. Contact your Toro Distributor.
1. The hopper is open. 1. Ensure that the hopper is closed all the
way.
2. The hydraulics are over heated. 2. Allow the machine to cool down and
reslove the heating issue; refer to your
Toro Distributor.
3. The fan belt is loose or broken. 3. Contact your Toro Distributor.
The fan turns off while operating the
machine.
4. The pump belt is loose or broken. 4. Contact your Toro Distributor.
The hydraulic quick-disconnect fittings are
difficult to remove or connect. 1. Some quick-disconnect fittings are
difficult to remove or connect.
1. Rotate the sleeve of the fitting until the
key lines up with the marking to allow
the fitting to release.
11