Figure 1
1.
Filler plug
2.
Check plug
Width of Cut: 72 inches (183 cm)
Height of Cut: Adjustable from 5–12.7 cm in 1.25 cm increments.
Cutter Housing: 12-gauge steel and reinforced with 2-1/2" x 10
gauge channel.
Cutting Unit Drive: Power is transmitted to the blades by one hex
B section belt. Spindle shafts are 3.2 cm diameter and supported by
two externally-sealed, greaseable, tapered roller bearings.
Cutting Unit: The cutting unit has front and rear castor wheels, and
three heat-treated steel blades 63.5 cm long and 6.3 mm thick.
Castor Wheels: The two front castor wheels have roller bearings
with 10.25 in x 3.25 in. hard rubber tires. The rear wheels have
roller bearings and 8 in. x 3.50 in. hard rubber tires.
Blade Tip Speed: At 3200 engine rpm, blade tip speed is 15,800
ft/min.
Cutting Unit Lift: The cutting unit is lifted by a hydraulic cylinder
that has a 6.3 cm bore and 8.3 cm stroke.
Dimensions and Weights:
Width: 190.5 cm
Weight: 172 kg
Specifications and design are subject to change without notice.
CHECK THE GEAR BOX LUBRICANT
(Fig. 1)
The gear box in designed to operate on SAE 80-90 weight gear
lubrication. Although the gear box is shipped from the factory with
lubricant, check the level before operating the cutting unit.
1.
Position the machine and cutting unit on a level surface.
2.
Remove the check plug from the side of the gear box and make
sure the lubricant level is up to the bottom of the hole. If the
level of lubricant is low, remove the fill plug on top of the gear
9
Specifications
Before Operating
