Toro 30654, Руководство оператора

Страница: 33 / 60

Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Note:
To obtain an electrical schematic or a hydraulic schematic for your machine, visit www.toro.com/en-gb .
Maintenance Safety
•
Before you leave the operator’s position, do the
following:
– Park the machine on a level surface.
– Disengage the cutting unit(s) and lower the
attachments.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all movement to stop.
•
Allow machine components to cool before
performing maintenance.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Support the machine with jack stands whenever
you work under the machine.
•
Carefully release pressure from components with
stored energy.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Replace all worn or damaged decals.
•
To ensure safe, optimal performance of the
machine, use only genuine Toro replacement
parts. Replacement parts made by other
manufacturers could be dangerous, and such use
could void the product warranty.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 8 hours
• Check the condition and tension of the alternator belt.
After the first 50 hours
• Change the engine oil and filter.
• Change the transmission oil filter.
• Change the hydraulic return filter.
• Check the engine speed (idle and full throttle).
Before each use or daily
• Inspect the seat belt(s) for wear, cuts, and other damage. Replace the seat belt(s) if
any component does not operate properly.
• Check the engine-oil level.
• Check the cooling system.
• Check fuel level.
• Check the level of the hydraulic fluid.
• Torque the wheel lug nuts.
• Check the tire pressure.
• Grease the bearings, bushings and pivots (grease them immediately after every
washing regardless of the interval listed).
• Check the air-cleaner blockage indicator (service the air cleaner earlier if the
air-cleaner indicator shows red; service it more frequently in extremely dirty or
dusty conditions).
• Remove debris from the screen, oil coolers, and radiator (more frequently in dirty
operating conditions).
• Check the safety interlock system.
• Check the hydraulic lines and hoses.
• Check the hydraulic lines and hoses for leaks, kinked lines, loose mounting supports,
wear, loose fittings, weather deterioration, and chemical deterioration.
Every 50 hours
• Grease the bearings, bushings and pivots (grease them immediately after every
washing regardless of the interval listed).
Every 100 hours
• Inspect the cooling system hoses.
• Check the condition and tension of the alternator belt.
Every 150 hours
• Change the engine oil and filter.
33