Toro 30609, Руководство оператора

Страница: 68 / 84

7. Add enough oil to bring the level up to the bottom
of the check plug holes; refer to
Changing the
Planetary-Gear-Drive Oil (page 66) .
8. Install the plugs.
Checking the Rear Wheel
Toe-In
Service Interval: Every 800 hours
1. Measure the center-to-center distance (at axle
height) at the front and rear of the steering tires.
Note:
The front measurement must be 6 mm
(1/4 inch) less than the rear measurement.
2. To adjust, loosen the clamps at both ends of the
tie rods.
3. Rotate the tie-rod end to move the front of the
tire inward or outward.
4. Tighten the tie-rod clamps when the adjustment
is correct.
Cooling System
Maintenance
Cooling System Safety
•
Swallowing engine coolant can cause
poisoning; keep out of reach from children and
pets.
•
Discharge of hot, pressurized coolant or touching
a hot radiator and surrounding parts can cause
severe burns.
– Always allow the engine to cool at least 15
minutes before removing the radiator cap.
– Use a rag when opening the radiator cap, and
open the cap slowly to allow steam to escape.
Checking the Cooling
System
Service Interval: Before each use or daily
Check the coolant level at the beginning of each day.
The capacity of the system is 8.5 L (9 US qt).
1. Carefully remove the radiator cap and
expansion-tank cap (
Figure 97 ).
2. Check the coolant level in the radiator.
Note:
The radiator should be filled to the top
of the filler neck and the expansion tank filled
to the Full mark.
g020441
Figure 97
1. Expansion tank
3. If the coolant is low, add a 50/50 mixture of water
and ethylene glycol anti-freeze.
Important:
Do not use water only or
alcohol/methanol base coolants, as this may
cause damage.
4. Install the radiator cap and expansion-tank cap.
68