Toro 30506, Руководство оператора

Страница: 3 / 20

Procedure Description Qty. Use
Bumper 1
Capscrew, 5/16 x 3 inch 4
10
Locknut, 5/16 inch 4
Install bumper
Trim molding 1
11
Deck cover 1
Install the new deck cover.
Belt guard 1
12
Pulley guard 1
Install the new safety guards.
13
Counterbalance spring 1 Install the new counterbalance spring.
14
No parts required
–
Install the cutting unit to the traction unit.
15
Decal, danger 1 Install the new decal.
16
Chute assembly 1 Mount the blower housing chute.
Media and Additional Parts
Description Qty. Use
Installation instructions 1 Read before installation
Certificate of compliance 1 CE certification
1
Removing the Cutting Unit
from the Traction Unit
No Parts Required
Procedure
1. Position the machine on a level surface, raise
the cutting unit, engage the parking brake,
ensure that the traction pedal is in the neutral
position and the PTO lever in the O
FF
position,
shut off the engine, and remove the key from
the switch.
CAUTION
The counterbalance spring is in tension
when the deck is in the lower position
(200 Series traction units only).
Always raise the deck before adjusting
or removing the spring.
2. On 200 Series traction units only, disconnect the
counterbalance from the traction unit, remove
the lock pins from the brackets, separate the
spring tension assemblies from the brackets,
and lay them down on the deck. Loosely secure
the lock pins to the brackets to prevent losing
them (
Figure 1 ).
g012533
Figure 1
1. Lock pin
3. Spring tension assembly
2. Bracket
3. Lower the cutting unit and remove the 4 bolts
and nuts securing lift arm brackets to castor
arms (
Figure 2 ).
3