Maintain the air pressure in the rear tires at 12-14 psi
(83-97 kPa). Uneven tire pressure can cause an uneven
cut.
Note:
The front tires are semi-pneumatic tires and do
not require air pressure maintenance.
Figure 42
Replacing the Caster Wheel
Fork Bushings
The caster wheel forks are mounted in bushings pressed
into the top and bottom of the carrier frame mounting
pivot tubes. To check the bushings, move the caster
forks back and forth and side-to-side. If a caster fork is
loose, the bushings are worn and must be replaced.
1. Raise the cutting unit so the caster wheels are off
the floor, then support the front of the mower with
jack stands.
2. Remove the locking pin and spacer(s) from the top
of the caster wheel fork (Figure 43).
Figure 43
1.
Locking Pin
3.
Carrier frame pivot tube
2.
Spacers
4.
Caster wheel fork
3. Pull the caster wheel fork out of the mounting tube,
leaving the spacer(s) on the bottom of the fork.
Remember the location of the spacers on each fork
to ensure correct installation, and to maintain a level
deck.
4. Insert a pin punch into the mounting tube and
carefully drive out the bushings (Figure 44). Clean
the inside of the mounting tube.
Figure 44
1.
Mounting Tube
2.
Bushing
5. Grease the inside and outside of the new bushings.
Use a hammer and flat plate to carefully drive the
bushings into the pivot tubes.
34
Содержание 30484
Страница 56: ...Schematics Hydraulic Schematic Rev A 56...
Страница 57: ...Electrical Schematic Rev A 57...
Страница 58: ...Notes 58...
Страница 59: ...Notes 59...
