Toro 30436, Руководство оператора

Страница: 41 / 60

41
m–6607
4
3
5
12
3
6
9
Side View
2
2
4
1
1
Figure 50
1. Speed control rod
2. Nut
3. Speed control crank
4. Tabs in 6 o’clock position
5. Swivel
7. Pull the speed control lever back to neutral.
8. Check to make sure the safety switch is depressed and
there is an 1/8 to 1/4 inch (3 to 6 mm) space between
the actuating tab and the safety switch (Fig. 51).
1
2
3
m–6604
5
4
Figure 51
1. Actuating tab
2. 1/8 to 1/4 inch space
3. Neutral safety switch
4. Neutral bracket
5. Neutral bracket screws
9. To adjust the switch location, loosen the two neutral
bracket screws holding the switch plate to the frame
(Fig. 51).
10. Adjust the switch up or down to obtain an 1/8 to
1/4 inch (3 to 6 mm) space (Fig. 51).
11. Tighten the two neutral bracket screws holding the
switch plate (Fig. 51).
Temporary Neutral Stud
Adjustment
1. Move the left and right hand neutral lock latches to the
unlatched position (Fig. 14).
2. Move the speed control lever to the neutral position
(Fig. 49).
3. Loosen the nut against the yoke (Fig. 52).
4. Adjust the length of the neutral stud and yoke
assembly so the clevis pin does not contact the back of
the slot in the control arm bracket (Fig. 52).
5. Tighten the nut against the yoke (Fig. 52).
3
4
2
1
5
m–6641
6
6
7
Figure 52
1. Neutral control linkage
2. Yoke
3. Neutral stud
4. Nut
5. Slot in control arm bracket
6. Clevis pin
7. Clevis pin does not
contact the back of slot
Adjusting the Hydro Control
Linkages
Engine must be running so control linkage
adjustments can be performed. Contact with
moving parts or hot surfaces may cause personal
injury.
Keep hands, feet, face, clothing and other body
parts away from rotating parts, muffler and other
hot surfaces.
Warning