Toro 30413, Руководство оператора

Страница: 42 / 64

Figure 56
1. Fuses
Figure 57
1. Power outlet
5. Starter solenoid
2. Seat switch
6. Light Kit
3. Ignition switch 7. Fan
4. Power Take Off (PTO) 8. Power seat
Drive System
Maintenance
Changing the Planetary Gear
Drive Oil
Service Interval: After the first 200 hours
Every 800 hours
Change the oil initially after first 200 hours of operation.
Thereafter change the oil every 800 hours, or yearly,
whichever occurs first. Use a high quality SAE 85W-140
gear lube.
1. With the machine on a level surface, position the
wheel so that the check/drain plug (Figure 58) is at
the lowest position.
Figure 58
1. Check/drain plug
2. Place a drain pan under the hub, remove the plug,
and allow the oil to drain.
3. When all of the oil has drained, position the wheel
so that the plug hole is at the ten or two o’clock
position.
4. Place a drain pan under the brake housing on the
other side of the wheel (Figure 59).
5. Remove the plug from the bottom of the housing
and allow the oil to drain.
6. When all of the oil has drained, install the plug in
the housing.
7. Remove check plug from brake housing (Figure 59).
8. Add high quality SAE 85W-140 wt gear lube to the
planetary fill hole (at the ten or two o’clock position)
and to the check hole in brake housing until the
42