Toro 30349, Руководство по установке

Страница: 15 / 20

g215450
Figure 25
1. Hairpin cotter 3. Pin
2. Roll bar
B. Insert a washer (13/16 x 1-1/2 inches) onto
each bolt (3/4 x 4 inches) as shown in
Figure 26 .
g215449
Figure 26
1. Nut (3/4 inch) 3. Washer (13/16 x 1-1/2
inches)
2. Roll bar 4. Bolt (3/4 x 4 inches)
C. In the holes where the pins were removed,
install the bolts and washers (
Figure 26 ).
D. Install another washer onto each bolt and
secure with nut (3/4 inch) as shown in
Figure 26 .
E. Torque the ROPS pivot bolt to 91 to 113
N∙m (67 to 83 ft-lb) to avoid any bouncing
of the roll bar and sunshade.
3. On each side of the sunshade frame, loosely
mount a brace to the second hole of the brace
bracket with a bolt (1/2 x 2-1/2 inches), washer
(1/2 inch), and flange nut (1/2 inch) as shown
in
Figure 27 .
g020206
Figure 27
1. Bolt (1/2 x 2-1/2 inches) 6. Second hole
2. Washer (1/2 inch) 7. Third hole
3. Brace 8. Rear hole
4. Front hole 9. Brace bracket
5. Flange nut (1/2 inch)
4. Loosely install a brace bracket to each brace
with a bolt (1/2 x 2-1/2 inches), washer (1/2
inch), and flange nut (1/2 inch) as shown in
Figure 27 .
5. Position the ROPS-mounting brackets onto
the top of the traction unit roll bar (
Figure
28 ). Ensure that the roll bar is centered in the
ROPS-mounting brackets.
Note:
Use the ROPS-mounting bracket from
the installation kit (Part No. 136-1830) for
Groundsmaster 4500 and 4700 machines with
serial number 400000001 and higher.
g019766
Figure 28
1. ROPS-mounting bracket 4. Flange nut (3/8 inch)
2. Roll bar post
5. U-bolt (2-3/4 inch)
3. U-bolt (4 inches)
6. Using the mounting holes shown in Figure 28 ,
mount each ROPS-mounting bracket to the top
of the roll bar with 2 U-bolts (2-3/4 inch) and 4
flange nuts.
Note:
Use the U-bolt (3-1/2 x 5 inches) from
the installation kit (Part No. 136-1830) for
Groundsmaster 4500 and 4700 machines with
serial number 400000001 and higher.
15