Toro 30349, Руководство по установке

Страница: 6 / 20

Installing the Sunshade
Groundsmaster 5900 Machine
1. To properly align the frame, attach the
frame-alignment bar to the mounting tabs on the
rear of the sunshade frame with 2 flange-head
bolts (5/16 x 1-1/4 inches) as shown in
Figure 1 .
g020204
Figure 1
1. Sunshade frame
4. Mounting tab
2. Frame-alignment bar 5. Retainer nut
3. Flange-head bolt (5/16 x
1-1/4 inches)
2. On each side of the sunshade frame, loosely
mount a brace to the second hole of the brace
bracket with a bolt (1/2 x 2-1/2 inches), washer
(1/2 inch), and flange nut (1/2 inch) as shown
in
Figure 2 .
g020022
Figure 2
1. Bolt (1/2 x 2-1/2 inches) 6. Second hole
2. Washer (1/2 inch) 7. Third hole
3. Brace 8. Rear hole
4. Front hole 9. Brace bracket
5. Flange nut (1/2 inch)
3. Loosely install a brace bracket to each brace
with a bolt (1/2 x 2-1/2 inches), washer (1/2
inch), and flange nut (1/2 inch) as shown in
Figure 2 .
4. Position the ROPS-mounting brackets onto the
top of the traction unit roll bar (
Figure 3 ).
Note:
Make sure that the roll bar is centered in
the mounting brackets.
g019761
Figure 3
1. ROPS-mounting bracket 3. U-bolt (4 inches)
2. Roll bar post 4. Flange nut (3/8 inch)
5. Using the mounting holes shown in Figure 3 ,
mount each ROPS-mounting bracket to the top
of the roll bar with 2 U-bolts (4 inches) and 4
flange nuts.
6. Using the mounting holes shown in Figure 3 ,
loosely secure each of the brace brackets to
the roll bar posts with a U-bolt (4 inches) and
2 flange nuts.
7. Move the brace bracket up or down, on the
vertical roll bar posts, until the sunshade frame
is level to the floor.
Note:
Use a level to make sure that the frame
is level to the ground.
Note:
Use the front or rear mounting holes in
the brace bracket, if you need more adjustability.
8. Tighten the U-bolt flange nuts, securing the
mounting brackets to the posts.
9. Tighten all the remaining flange nuts as follows:
•
Torque the flange nuts (3/8 inch) 41 to 55
N∙m (34 to 41 ft-lb).
•
Torque the flange nuts (1/2 inch) 113 to 141
N∙m (84 to 104 ft-lb).
10. Remove the flange-head bolts securing the
frame-alignment bar to the frame and remove
the alignment bar. Retain the bolts for mounting
the sunshade.
6