Toro 30257, Руководство оператора

Страница: 34 / 48

34
5. If the height at location A and B are not the same,
change tire pressure slightly to make them the same.
3
2
m–5237
A B
1
3
4 4 4
Figure 49
1. Back view of machine
2. Top of engine deck
3. Tires
4. Same height at locations
A and B
Checking Carrier Frame Front–to–Rear
Pitch
The carrier frame must have a pitch of a 1/4 in. (6 mm)
over the length of 24 inches (6.1 mm) on the carrier
frame.
1. Measure out 24 inches (6.1 mm) on the carrier frame
(Fig. 50).
2. Measure carrier frame height at location A (Fig. 50).
3. Measure carrier frame height at location B (Fig. 50).
4. The height at location A must be a 1/4–3/8 in.
(6 mm – 10 mm) lower than location B (Fig. 50).
5. If the carrier frame is not correct, move caster spacers
to make it a 1/4–3/8 in. (6 mm – 10 mm) pitch
(Fig. 50). Move spacers from top or bottom to make
the correct pitch.
6. The tire pressure may also be adjusted slightly to make
a 1/4–3/8 in. (6 mm – 10 mm) pitch.
24 in.
1
2
m–5242
A B
3
4
4
5
5
6.1 cm
Figure 50
1. Caster Wheel
2. Carrier Frame
3. 1/4–3/8 in. (6 mm–10 mm)
pitch over 24 in. (6.1 cm)
length
4. Height at locations A
and B
5. Caster spacers
Checking Carrier Frame Side–to–Side
1. Stop the engine, remove the key and disconnect the
spark plug wire(s) from the spark plug(s).
2. Adjust the tire pressure in all tires to specifications on
page 28.
3. Measure carrier frame height at location A (Fig. 51).
4. Measure carrier frame height at location B (Fig. 51).
5. If the carrier frame height is not the same move
spacers from top or bottom of caster wheel, to make it
level. The tire pressure may also be adjusted slightly to
make it level.
5
1
m–5231
A B
2
4
4
1
2
3
5
Figure 51
1. Caster Wheel
2. Carrier Frame
3. Front height–of–cut pins
4. Same height at locations
A and B
5. Caster spacers