Toro 30241 Groundsmaster 228-D, Руководство оператора

Страница: 31 / 40

31
To thoroughly clean the radiator:
1. Remove the screen.
2. Working from the fan side of the radiator, either spray
the radiator with a water hose or blow with compressed
air.
3. After the radiator is thoroughly cleaned, clean out
debris that may have collected in the channel at the
radiator base.
4. Clean and install the screen.
Changing Engine Oil And Filter
Check oil level after each day’s operation or each time
machine is used. Change oil after every 50 hours of
operation; change oil filter after first 50 hours and every
100 hours operation thereafter. If possible, run engine just
before changing oil because warm oil flows better and
carries more contaminants than cold oil.
1. Position machine on a level surface.
2. Open the hood. Set drain pan under the oil pan and in
line with drain plug (Fig. 31).
3. Clean area around drain plug.
1
Figure 31
1. Drain plug
4. Remove oil drain plug and allow oil to flow into drain
pan.
5. Remove and replace oil filter (Fig. 32).
1
Figure 32
1. Oil filter
6. After oil is drained, reinstall drain plug and wipe up any
oil that is spilled.
7. Fill crankcase with oil; refer to Check Crankcase Oil.
Servicing Fuel System
Note: Refer to Fill Fuel Tank With Diesel Fuel for proper
fuel recommendations.
Fuel Tank
Drain and clean fuel tank every 800 hours operation or
yearly, whichever comes first. Also, drain and clean tank if
fuel system becomes contaminated or if machine is to be
stored for an extended period. Use clean diesel fuel to flush
out the tank.
Fuel Lines and Connections
Check lines and connections every 400 hours or yearly,
whichever comes first. Inspect for deterioration, damage or
loose connections.
Water Separator
Drain water or other contaminants from water separator
(Fig. 33) daily.
1. Place a clean container under fuel filter.
2. Loosen drain plug on bottom of filter canister. Tighten
plug after draining.