Toro 30184 ProLine, Руководство оператора

Страница: 45 / 52

Maintenance
43
Adjusting Grass\Mud Scraper
1. Remove belt guard.
2. Loosen the locknut holding scraper to the engine
frame (Fig. 49).
3. Rotate scraper until they align with center of
pulley grooves (Fig. 49).
4. Tighten the locknut (Fig. 49).
Note: The scraper must not contact the pulley
on the sides or bottom of grooves.
Re-adjust if necessary.
2
3
1
m–3821
Figure 49
1. Scraper
2. Locknut
3. Pulley
Replacing the Grass Deflector
1. Remove the locknut, bolt, spring and spacer
holding deflector to the mounts (Fig. 50).
2. Straighten deflector mounts if they are bent
(Fig. 50).
3. Install new deflector between mounts with
spacer and spring. Place spacer through spring
and hook the front end of the spring around the
front deflector mount. Insert bolt through mounts
and spacer. Secure with locknut. Confirm there
is downward spring force on deflector (Fig. 50).
4. Tighten the bolt and locknut until they lightly
contact the pivot brackets (Fig. 50).
IMPORTANT: The grass deflector must be
spring-loaded in the down position. Lift the
deflector up to test that it snaps to the full
down position.
5
6
3
1
2
m–3781
4
Figure 50
1. Deflector
2. Bolt
3. Deflector mount
4. Spring
5. Spacer
6. Locknut