Toro 30144, Руководство оператора

Страница: 7 / 20

6
SET-UP INSTRUCTIONS
INSTALL CASTOR WHEELS
1. Place (2) thrust washers onto castor wheel shaft
(Fig. 1).
2. If cutting unit is to be mounted on a traction unit
with a serial number of 590001 & up, position a caster
wheel spacer (Fig. 1) below carrier frame, when
mounting caster wheels. When mounting cutting units
on traction units with serial number prior to 5900001
place the spacer above carrier frame.
1474
4
4
3
1
2
5
Figure 1
1
Castor wheel assembly
2
Carrier frame
3
Spacer
4
Thrust washer
5
Retaining ring
3. Insert shaft into carrier frame mounting tube. Install
(2) thrust washers and secure with retaining ring
(Fig. 1).
4. On traction unit
s prior to Serial No. 590001 install
1”–4” height-of-cut decal over existing 2”–5” decal.
MOUNT CARRIER FRAME TO TRACTION
UNIT
1. Align carrier frame holes with mounting holes in
traction unit frame. Secure each side with three (3)
flange screws and lock nuts. Position bottom lock nut
outside frame. Torque mounting screws to 60-80 ft.
lbs. (81-109 Nm).
1
2
1074
Figure 2
1
Carrier frame
2
Traction frame
MOUNT CUTTING DECK
1. Position cutting deck under carrier frame.
2. Mount cutting unit to carrier frame with four (4)
clevis pins and hair pin cotters (Fig. 5).
Note: All four pins must be in the same hole locations
to prevent uneven cutting.