Toro 29642, Руководство оператора

Страница: 16 / 20

Figure 29
2. When no more clippings come out, stop the water
and move the mower to a dry area.
3. Run the engine for a few minutes to dry the housing
to prevent it from rusting.
Storage
Store the mower in a cool, clean, dry place.
Preparing the Mower for
Storage
WARNING
Gasoline vapors can explode.
• Do not store gasoline more than 30 days.
• Do not store the mower in an enclosure near an
open flame.
• Allow the engine to cool before storing it.
1. On the last refueling of the year, add fuel stabilizer
to the fuel as directed by the engine manufacturer.
2. Run the mower until the engine stops from running
out of fuel.
3. Prime the engine and start it again.
4. Allow the engine to run until it stops. When you can
no longer start the engine, it is sufficiently dry.
5. Disconnect the wire from the spark plug and connect
the wire onto the retaining post.
6. Remove the spark plug, add 1 oz. (30 ml) of oil
through the spark plug hole, and pull the starter rope
slowly several times to distribute oil throughout the
cylinder to prevent cylinder corrosion during the
off-season.
7. Install the spark plug and tighten it with a torque
wrench to 15 ft-lb (20 N
⋅
m).
8. Tighten all nuts, bolts, and screws.
9. Charge the battery for 24 hours, then unplug the
battery charger and store the mower in an unheated
area. If you must store the mower in a heated area,
you must charge the battery every 90 days.
Folding the Handle
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Loosen the handle knobs until you can move the
handle freely (Figure 30).
Figure 30
1. Handle knob (2)
2. Move the handle forward as shown in Figure 30.
Removing the Mower from
Storage
1. Charge the battery for 24 hours.
2. Connect the wire to the spark plug.
16