Toro 29639, Руководство оператора

Страница: 10 / 20

Removing the Grass Bag
1. Lift up the rear deflector (Figure 19).
2. Lift the grass bag handle out from the notches on the
handle brackets and remove the bag from the machine.
3. Close the rear deflector.
Discharging the Clippings
Use the rear-discharge deflector (optional attachment; Toro
part 89964) for cutting very tall grass.
Installing the Rear-discharge Deflector
1. If the bag is on the machine, remove it; refer to
Removing the Grass Bag (page 10).
2. Lift up the rear deflector and hold it (Figure 20).
G020689
Figure 20
3. Insert the tab on the rear-discharge deflector into the
right-hand slot in the rear deflector (Figure 21).
G020690
Figure 21
4. Insert the rod on the rear-discharge deflector into the
notches on the machine (Figure 22).
G020691
Figure 22
Removing the Rear-discharge Deflector
To remove the rear-discharge deflector, reverse the steps
above.
Operating Tips
General Mowing Tips
•
Clear the area of sticks, stones, wire, branches, and other
debris that the blade could hit.
•
Avoid striking solid objects with the blade. Never
deliberately mow over any object.
•
If the machine strikes an object or starts to vibrate,
immediately stop the engine, disconnect the wire from
the spark plug, and examine the machine for damage.
•
For best performance, install a new blade before the
cutting season begins.
•
Replace the blade when necessary with a Toro
replacement blade.
Cutting Grass
•
Cut only about a third of the grass blade at a time. Do
not cut below the 51 mm setting unless the grass is sparse
or it is late fall when grass growth begins to slow down.
Refer to Adjusting the Cutting Height (page 8).
•
When cutting grass over 15 cm (6 inches) tall, mow at the
highest cutting-height setting and walk slower; then mow
again at a lower setting for the best lawn appearance. If
the grass is too long, the machine may become clogged
and cause the engine to stall.
•
Mow only dry grass or leaves. Wet grass and leaves tend
to clump on the yard and can cause the machine to
become clogged or the engine to stall.
WARNING
Wet grass or leaves can cause serious injury if
you slip and contact the blade. Mow only in dry
conditions.
•
Alternate the mowing direction. This helps disperse the
clippings over the lawn for even fertilization.
•
If the finished lawn appearance is unsatisfactory, try one
or more of the following:
10