Toro 26638, Руководство оператора

Страница: 6 / 24

INSTALLING HANDLEĊLoosen knobs on
mounting brackets (Fig. 1).
Position mounting brackets in a vertical position so
that holes face up.
Slide handle ends into holes in mounting brackets
until handle ends are completely seated in brackets
(Fig. 1). Make sure cables rest on top of mounting
brackets (Fig. 2).
'%0-#
*")#
+0*/'*% -!(#/ *+
+0.'*% ,+!(#/
811
Rotate handle and brackets rearward until
brackets fit securely into housing pockets (Fig. 2).
&-+//)# ! )#
'%0-#
809
-!/'+* ! )#
#-.&'$/ ! )#
Tighten knobs until edges of slots on top of
mounting brackets touch.
Use cable ties to secure cables to lower ends of
handle tubes (Fig. 3). Cable ties should be positioned
25 mm (1") from bend in handles. See Figure 3 for
correct placement.
+/# Make sure cables do not interfere with the
raising or lowering of discharge door.
Cut excess length from ends of cable ties.
'%0-#
)# /'#
810
Pull the starter rope through the rope guide on
the handle (Fig. 4). To make the rope easier to loop,
squeeze the control bar on the handle to release the
blade brake.
+,# %0'"# /-/#- -+,#
M-2882
'%0-#