Toro 23740, Руководство оператора

Страница: 16 / 24

Checking the Engine Oil Level
Service Interval: Before each use or daily
Engine Oil Type: Toro 4–Cycle Premium Engine Oil
1. Turn off the engine and wait for all moving parts to
stop. Make sure the unit is on a level surface.
2. Check the oil level once the engine is cold.
3. Clean the area around the dipstick. Remove the dipstick
and wipe the oil off. Insert the dipstick according to
the engine manufacturer's recommendations. Remove
the dipstick and read the oil level.
4. If the oil level is low, wipe off the area around the oil
fill cap, remove the cap and fill to the Full mark on
the dipstick. Toro 4-Cycle Premium Engine Oil is
recommended; refer to the
Engine Owner's manual for
an acceptable alternative.
Note:
Do not overfill.
Note:
Do not operate the engine with the oil level below the
Low or Add mark on the dipstick, or over the Full mark.
Checking the Traction Cable
Service Interval: After the first 2 hours
Yearly
1. Turn off the engine, wait for all moving parts to stop,
and remove the spark plug wire(s).
2. With the traction lever disengaged, check the pin in the
elongated slot in the left side of the machine above the
tire (Figure 13). There should be a gap of 6 mm (1/4
inch) from the front of the slot to the front edge of
the pin. If adjustment is necessary, see Adjusting the
Traction Cable (page 18).
Figure 13
1. Pin 2. 6 mm (1/4 inch)
Checking for Loose Hardware
Service Interval: Before each use or daily
1. Turn off the engine, wait for all moving parts to stop,
and remove the spark plug wire(s).
2. Visually inspect the machine for any loose hardware or
any other possible problem. Tighten the hardware or
correct the problem before operating.
Changing the Engine Oil
Service Interval: After the first 5 hours
Every 100 hours (more frequently in severe
conditions).
1. Turn off the engine and wait for all moving parts to
stop.
2. Disconnect the wire from the spark plug.
3. Drain the oil while the engine is warm from operation.
4. Place a pan under drain fitting and remove the oil drain
plug. Allow the oil to drain and replace the oil drain
plug.
5. Clean around the oil fill cap and remove the cap. Fill
to the specified capacity and replace the cap. Use the
oil recommended in the Checking the Engine Oil Level
(page 16) section. Do not overfill.
6. Start the engine and check for leaks. Stop the engine
and recheck the oil level.
7. Wipe up any spilled oil from the engine deck mounting
surfaces.
Checking the Tire Pressure
Service Interval: Every 50 hours
1. Turn off the engine, wait for all moving parts to stop,
and leave engine switch in the Off position.
2. Check the tire pressure in the drive tires.
3. Inflate the drive tires to 117-138 kPa (17-20 psi).
Checking the Condition of the
Belts
Service Interval: Every 50 hours
1. Turn off the engine, wait for all moving parts to stop,
and remove the spark plug wire(s).
2. Remove the belt cover and engine shield to check the
belt condition.
Lubricating the Broom Angle
Lock Pin and Hex Shaft
Service Interval: Every 100 hours
Yearly
1. Turn off the engine, wait for all moving parts to stop,
and leave the engine switch in the Off position.
16