Toro 23518, Руководство оператора, Страница: 52 / 56

Problem Possible Cause Corrective Action
1. The transmission belt worn, loose or
broken.
1. Change the belt. The machine does not drive.
2. The transmission belt is off a pulley. 2. Change the belt.
1. A tine is bent. 1. Install a new tine.
2. The tine mounting bolt is loose. 2. Tighten the tine mounting bolt.
3. The engine mounting bolts are loose. 3. Tighten the engine mounting bolts.
4. There is a loose engine pulley or idler
pulley.
4. Tighten the appropriate pulley.
5. The engine pulley is damaged. 5. Contact an Authorized Service Dealer.
6. A belt is damaged. 6. Install a new belt.
There is abnormal vibration.
7. The chains are not properly tensioned. 7. Check the jackshaft drive chain
tension, the drive wheel chain tension,
and the tine drive chain tension.
1. There is an auxiliary pump belt
problem.
1. Tension or replace the belt.
2. The tine down pressure setting is too
low.
2. Increase the down pressure.
3. There is a short in the wiring harness. 3. Contact an Authorized Service Dealer.
The tines do not raise.
4. The auxiliary reservoir is low on oil. 4. Add oil to the reservoir.
1. The tine down pressure setting is too
low.
1. Increase the tine down pressure.
2. The harness/switch is damaged. 2. Contact an Authorized Service Dealer.
3. The auxiliary reservoir is low on oil. 3. Add oil to the reservoir.
The tines do not engage the ground.
4. The cylinder stop is in place (model
39518).
4. Remove the cylinder stop, clevis pin,
and hair pin.
52