Toro 22805, Руководство оператора

Страница: 6 / 16

Operation
Refer to your traction unit Operator’s Manual for more
information on installing and removing attachments on your
traction unit.
Note:
Always use the traction unit to lift and move the
attachment. To move an auger without the drive head, sling
a strap over each end of the auger and hoist it to the desired
location.
Installing an Auger
WARNING
The auger head swings freely in the cradle arms.
Your hands or fingers could get pinched and
severely injured or amputated if they are caught
between the cradle arms and the swinging drive
head.
Keep your hands and fingers away from the cradle
arms.
1. If you are installing an auger on model 22806 drive
head, position the drive head vertically, slide a bolt (1/2
x 2-1/2 inches) into the holes in the front cradle arms,
and secure it lightly with a flange nut (1/2 inch) (
Figure
4 ).
g004515
Figure 4
1. Drive head (front view) 3. Front cradle arm
2. Bolt
2. Raise the loader arms so the drive head clears the
ground.
3. Stop the engine.
4. Manually rotate the auger drive head up, until you can
slide a bolt (1/2 x 2-1/2 inches) into the hole in the
cradle arm, securing the drive head. Lightly secure the
bolt with a flange nut (1/2 inch) (
Figure 5 ).
g004516
Figure 5
1. Drive head 3. Bolt and flange nut
2. Cradle arm
5. If using an extension with the auger, insert the end of
the extension into the end of the auger and secure the
auger to the extension with a bolt (7/8 x 4-1/2 inch)
and nut (7/8 inch) (
Figure 6 ).
g004517
Figure 6
6. Start the engine.
7. Maneuver the drive shaft into the end of the auger
shaft or extension (if applicable) (
Figure 7 ).
g004518
Figure 7
1. Drive head 2. Auger shaft
6