Toro 22618, Руководство оператора

Страница: 13 / 32

Lowering the Rail to the Horizontal
Position
1. Rotate the vertical lock lever to the open position
(
Figure 11 ).
2. Carefully rotate the rail into the horizontal
position (
Figure 11 ).
3. Install the lock pin to secure the rail ( Figure 11 ).
g393408
Figure 11
Splitting a Log
WARNING
This machine is capable of amputating hands
and feet.
Always stand in the operating zone shown in
Figure 12 .
g393413
Figure 12
1. Operating zone
1. Park the machine on level ground and adjust the
jack stand to ensure that the machine is level.
2. Chock both tires to prevent the machine from
moving.
3. Change the rail position, if desired, and lock it
into position; refer to
Changing the Rail Position
(page 12) .
4. Start the engine.
5. Ensure that the logs you are splitting are less
than 60 cm (24 inches) long and that both ends
are cut as flat as possible.
Note:
This prevents the log from sliding out of
position while under pressure.
6. Place the log against the end plate so that the
direction of the grain matches the direction of
movement for the splitting wedge.
13