Toro 22536, Руководство оператора

Страница: 8 / 16

CAUTION
Hydraulic couplers, hydraulic lines/valves,
and hydraulic fluid may be hot. If you contact
hot components, you may be burned.
• Wear gloves when disconnecting the
hydraulic couplers.
• Allow the machine to cool before touching
hydraulic components.
• Do not touch hydraulic fluid spills.
Starting the Power Rake
1. Start the traction unit and adjust the throttle to
H
IGH IDLE
.
2. Engage the auxiliary hydraulics.
3. Slowly lower the power rake to the ground.
4. Move the traction unit forward or backward as
desired.
Note:
For the roller to operate effectively, rotate
it in the opposite direction that the traction unit
is moving. The direction of the roller rotation is
controlled by the traction unit hydraulic controls;
refer to the table below.
Important:
Disengage the auxiliary
hydraulics and wait for the roller to stop
completely before changing the roller
direction.
Roller Rotation Travel Direction
Using the End Plates
The end plates contain the material in front of the
roller, while the clean material passes between the
roller and the barrier (
Figure 5 ). With the end plates
mounted in the working position and the rake straight
(parallel with the traction unit track), the material can
be moved, filling in low spots.
g271286
Figure 5
1. Pin 3. Storage location
2. End plate in working
position
Adjusting the Roller Height
1. Park the machine on a level surface, disengage
the auxiliary hydraulics, engage the parking
brake, and lower the loader arms.
2. Tilt the attachment plate rearward so that the
caster wheels are off the ground.
3. Shut off the engine and remove the key.
4. Remove the lynch pin from the caster wheel.
5. Remove the spacers and caster wheel ( Figure
6 ).
g271287
Figure 6
1. Install spacers to the
caster wheel to raise the
roller. 2. Remove spacers from the
caster wheel to lower the
roller.
8