10
CAUTION
POTENTIAL HAZARD
•
If you leave the key in the ignition switch, someone could start the engine.
WHAT CAN HAPPEN
•
Accidental starting of the engine could seriously injure you or other bystanders.
HOW TO AVOID THE HAZARD
•
Remove the key from the ignition switch before you do any maintenance.
Greasing and Lubrication
Service Interval/Specification
Grease one fitting on the broom pivot shaft (Fig. 13) with
a corrosion resistant, calcium-sulphonate based grease
before each use. Grease 8 other fittings, located on each
castor shaft (Fig. 14, only one side shown), on the right of
the the axle (Fig. 15), on the motor/axle linkage (Fig. 16),
on the right and left arms (Fig. 17, only one side shown),
and on the loader arm clamps (Fig. 8, only one side
shown), every 8 operating hours. Grease all fittings
immediately after every washing.
Grease Type: corrosion resistant, calcium-sulphonate
based grease (pivot shaft only) and general-purpose grease
(all other fittings).
Fitting Locations
m–4132
Figure 13
Figure 14
m–4134
Figure 15
m–4180
1
Figure 16
1. Knuckle joint inside the broom axle
m–4133
Figure 17
m–4130
Figure 18
How to Grease
1.
Lower the broom/loader arms and stop the engine.
Remove the key.
