Note:
If outdoor temperature is below freezing,
store the traction unit in a garage to keep it
warmer and to aid in starting.
Driving the Machine
Use the traction control to move the machine. The
farther you move the traction control in any direction,
the faster the machine moves in that direction.
Release the traction control to stop the machine.
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place the
throttle lever in the F
AST
position for best performance.
You can, however, use the throttle position to operate
at slower speeds.
Shutting Off the Engine
1.
Park the machine on a level surface, engage
the parking brake (if equipped), and lower the
loader arms.
2.
Ensure that the auxiliary hydraulics lever is in
the N
EUTRAL
position.
3.
Move the throttle lever to the S
LOW
position.
4.
If the engine has been working hard or is hot, let
it idle for a minute before turning the key switch
to the O
FF
position.
Note:
This helps to cool the engine before you
shut it off. In an emergency, you can shut off
the engine immediately.
5.
Turn the key switch to the O
FF
position and
remove the key.
CAUTION
A child or untrained bystander could attempt
to operate the traction unit and be injured.
Remove the key from the key switch when
leaving the traction unit, even if just for a few
seconds.
Using Attachments
Installing an Attachment
Important:
Use only Toro-approved attachments.
Attachments can change the stability and the
operating characteristics of the machine. The
warranty of the machine may be voided if you use
the machine with unapproved attachments.
Important:
Before installing the attachment,
ensure that the mount plates are free of any dirt or
debris and that the pins rotate freely. If the pins
do not rotate freely, grease them.
1.
Position the attachment on a level surface with
enough space behind it to accommodate the
machine.
2.
Start the engine.
3.
Tilt the attachment mount plate forward.
4.
Position the mount plate into the upper lip of the
attachment receiver plate (
).
g003710
Figure 4
1.
Mount plate
2.
Receiver plate
5.
Raise the loader arms while tilting back the
mount plate at the same time.
Important:
Raise the attachment enough to
clear the ground and tilt the mount plate all
the way back.
6.
Shut off the engine and remove the key.
7.
Engage the quick-attach pins, ensuring that they
are fully seated in the mount plate (
).
Important:
If the pins do not rotate to the
engaged position, the mount plate is not
fully aligned with the holes in the attachment
receiver plate. Check the receiver plate and
clean it if necessary.
10
