Toro 22306, Руководство оператора

Страница: 19 / 52

Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline. To
minimize the chance of varnish deposits in the fuel
system, use fuel stabilizer at all times.
Filling the Fuel Tank
1. Park the traction unit on a level surface, lower
the loader arms, and stop the engine.
2. Remove the key and allow the engine to cool.
3. Clean around the fuel tank cap and remove it.
4. Add unleaded gasoline to the fuel tank, until
the level is just below the bottom of the filler
neck.
Important:
This space in the tank allows
gasoline to expand. Do not fill the fuel
tank completely full.
5. Install the fuel tank cap securely.
6. Wipe up any gasoline that may have spilled.
Checking the Engine Oil
Level
1. Park the traction unit on a level surface, lower
the loader arms, and stop the engine.
2. Remove the key and allow the engine to cool.
3. Open the hood.
4. Clean around the oil dipstick (Figure 9).
Figure 9
1. Oil dipstick 2. Metal end
5. Pull out the dipstick and wipe the metal end
clean (Figure 9).
6. Slide the dipstick fully into the dipstick tube
(Figure 9).
7. Pull the dipstick out and look at the metal end.
8. If the oil level is low, clean around the oil filler
cap and remove the cap (Figure 10).
Figure 10
1. Filler cap 2. Valve cover
9. Slowly pour only enough oil into the valve
cover to raise the level to the F (full) mark.
Important:
Do not overfill the crankcase
with oil because the engine may be
damaged.
10. Replace the filler cap and dipstick.
11. Close the hood.
Checking the Hydraulic
Fluid Level
Check the hydraulic fluid level before the engine is
first started and after every 25 operating hours.
Hydraulic Tank Capacity: 12 US gallons (45.4 l)
Use 10W-30 detergent, diesel engine oil (API
service CH-4 or higher).
1. Remove the attachment, if one is installed;
refer to Removing an Attachment.
2. Park the traction unit on a level surface,
lower the loader arms, and fully retract the tilt
cylinder.
3. Stop the engine, remove the key, and allow the
engine to cool.
4. Open the hood.
5. Clean the area around the filler neck of the
hydraulic tank (Figure 11).
6. Remove the cap from the filler neck and check
the fluid level on the dipstick (Figure 11).
The fluid level should be between the marks
on the dipstick.
19