Toro 22291, Руководство оператора, Страница: 25 / 28

Troubleshooting
Problem Possible Cause Corrective Action
1. The fuel tank is empty or the fuel
system contains stale fuel.
1. Drain and/or fill the fuel tank with fresh
fuel. If the problem persists, contact an
Authorized Service Dealer.
2. The throttle lever is not in the C
HOKE
position.
2. Move the throttle lever to the C
HOKE
position.
3. The wire is not connected to the spark
plug.
3. Connect the wire to the spark plug.
The engine does not start.
4. The spark plug is pitted, fouled, or the
gap is incorrect.
4. Check the spark plug and adjust the
gap if necessary. Replace the spark
plug if it is pitted, fouled, or cracked.
1. The fuel tank contains stale fuel. 1. Drain and fill the fuel tank with fresh
fuel.
2. The air-filter element is dirty and is
restricting the air flow.
2. Clean the air-filter pre-cleaner and/or
replace the paper air filter.
3. The underside of the machine contains
clippings and debris.
3. Clean the underside of the machine.
4. The spark plug is pitted, fouled, or the
gap is incorrect.
4. Check the spark plug and adjust the
gap if necessary. Replace the spark
plug if it is pitted, fouled, or cracked.
The engine starts hard or loses power.
5. The engine-oil level is low or the oil is
dirty.
5. Check the engine oil. Change the oil if
it is dirty or add oil if it is low.
1. The wire is not connected to the spark
plug.
1. Connect the wire to the spark plug.
2. The spark plug is pitted, fouled, or the
gap is incorrect.
2. Check the spark plug and adjust the
gap if necessary. Replace the spark
plug if it is pitted, fouled, or cracked.
3. The throttle lever is not in the F
AST
position.
3. Move the throttle lever to the F
AST
position.
The engine runs rough.
4. The air-filter element is dirty and is
restricting the air flow.
4. Clean the air-filter pre-cleaner and/or
replace the paper air filter.
1. The blade is bent or is out of balance. 1. Balance the blade. If the blade is bent,
replace it.
2. The blade mounting nuts are loose. 2. Tighten the blade mounting nuts.
3. The underside of the machine contains
clippings and debris.
3. Clean the underside of the machine.
The machine or engine vibrates
excessively.
4. The engine mounting bolts are loose. 4. Tighten the engine mounting bolts.
1. All 4 wheels are not at the same height. 1. Place all 4 wheels at the same height.
2. The blade is dull. 2. Sharpen and balance the blade.
3. You are mowing in the same pattern
repeatedly.
3. Change the mowing pattern.
The cutting pattern is uneven.
4. The underside of the machine contains
clippings and debris.
4. Clean the underside of the machine.
1. The throttle lever is not in the F
AST
position.
1. Move the throttle lever to the F
AST
position.
2. The cutting height is too low. 2. Raise the cutting height.
3. You are mowing too fast. 3. Slow down.
4. The grass is wet. 4. Allow the grass to dry before mowing.
The discharge chute plugs up.
5. The underside of the machine contains
clippings and debris.
5. Clean the underside of the machine.
1. The self-propel drive cable is out of
adjustment or is damaged.
1. Adjust the self-propel drive cable.
Replace the cable if necessary.
The machine does not self-propel.
2. There is debris under the belt cover.
2. Clean the debris from under the belt
cover.
25