Toro 22282 Series, Руководство оператора

Страница: 20 / 32

Shutting Off the Machine
1. Release the blade-control bar (A of Figure 17 ).
2. Remove the electric-start button from the electric
starter (B of
Figure 17 ).
3. Remove the battery pack; refer to Removing the
Battery Pack from the Machine (page 20) .
Note:
Whenever you are not using the machine,
remove the battery pack.
g303233
Figure 17
Removing the Battery Pack
from the Machine
1. Lift up the battery-compartment lid.
2. Press the battery-pack latch to release the
battery pack and remove the battery pack.
3. Close the battery-compartment lid.
Operating Tips
General Mowing Tips
•
Avoid striking solid objects with the blade. Never
deliberately mow over any object.
•
For best performance, install a new blade before
the cutting season begins.
•
Replace the blade when necessary with a Toro
replacement blade.
Cutting Grass
•
Grass grows at different rates at different times
of the year. In the summer heat, it is best to cut
grass at the 64 mm (2-1/2 inch), 76 mm (3 inch),
or 89 mm (3-1/2 inch) cutting-height settings. Cut
only about a third of the grass blade at a time.
Do not cut below the 64 mm (2-1/2 inch) setting
unless the grass is sparse or it is late fall when
grass growth begins to slow down. For improved
runtime, cut grass at a higher height of cut.
•
When cutting grass over 15 cm (6 inches) tall, first
mow at the highest cutting-height setting and a
slower speed; then mow again at a lower setting
for the best lawn appearance. If the grass is too
long and the leaves clump on top of the lawn, the
machine may plug and cause the motor to stall.
•
Wet grass and leaves tend to clump on the yard
and can cause the machine to plug or the motor to
stall. Avoid mowing in wet conditions.
•
Be aware of a potential fire hazard in very dry
conditions, follow all local fire warnings, and keep
the machine free of dry grass and leaf debris.
•
Alternate the mowing direction. This helps
disperse the clippings over the lawn for even
fertilization.
If the finished lawn appearance is unsatisfactory, try 1
or more of the following:
•
Sharpen the blade.
•
Mow at a slower pace.
•
Raise the cutting height on your machine.
•
Cut the grass more frequently.
•
Overlap cutting swaths instead of cutting a full
swath with each pass.
20